ODLC-45 IP67 Constant Current and 0-10V Dimming Cheap

Product Liability Disclaimer：For detailed information, please refer to https: www.meanwell.com serviceDisclaimer.aspx 0.42Kg; 24pcs 11Kg 0.72CUFT ENVIRONMENT SAFETY & EMC PROTECTION WITHSTAND VOLTAGE ISOLATION RESISTANCE I P-O P:3.75KVAC I P-O P:100M Ohms 500VDC 25℃ 70% RH SAFETY STANDARDS Compliance to EN55015, EN61000-3-2 Class C (@load≧60%) ; EN61000-3-3,GB17743,GB17625.1,EAC TP TC 020 EMC IMMUNITY EMC EMISSION 111*77*28.5mm(L*W*H) Compliance to EN61000-4-2,3,4,5,6,8,11; EN61547, light industry level(surge immunity:Line-Line:1KV),EAC TP TC 020 UL8750(type”HL”),CSA C22.2 NO.250.13-12;ENEC EN61347-1 & EN61347-2-13 independent, EN62384,GB19510.1,GB19510.14; TOTAL HARMONIC DISTORTION VOLTAGE RANGE Note.3 ODLC-45 -350 ODLC-45 -700 ODLC-45 -1400 350mA 700mA 1400mA 33.25W 44.8W 44.8W 118V 500ms 230VAC 1200ms 115VAC 47 ~ 63Hz PF>0.95 115VAC, PF>0.92 230VAC, PF>0.9 277VAC@full load (Please refer to POWER FACTOR (PF) CHARACTERISTIC section) 86% 85% 83% 0.6A 115VAC 0.4A 230VAC 0.3A 277VAC COLD START 30A(twidth=100μs measured at 50% Ipeak) at 230VAC; Per NEMA 410 57 ~ 95V 38 ~ 64V 19 ~ 32V 84V 50V ODLC-45 -500 500mA 45W 85% 54 ~ 90V 115V ODLC-45 -1050 1050mA 45.15W 84% 26 ~ 43V 63V RATED CURRENT RATED POWER CURRENT TOLERANCE CONSTANT CURRENT REGION Note.2 OPEN CIRCUIT VOLTAGE(max.) CURRENT RIPPLE ±7.0% 5% max. @rated current THD< 20%(@load≧60% 230VAC; @load≧75% 277VAC) (Please refer to “TOTAL HARMONIC DISTORTION” section) MAX. No. of PSUs on 16A CIRCUIT BREAKER 32 units (circuit breaker of type B) 32 units (circuit breaker of type C) at 230VAC (Please refer to STATIC CHARACTERISTIC section) 90 ~ 295VAC AUXILIARY DC OUTPUT Note.5 Nominal 12V(deviation 11.4~12.6)@50mA for ODLC-45A only 45W Constant Current Mode LED Driver ODLC-45 seri e s No load power consumption<0.5W for Blank-Type,<1.2W for ODLC-45A Standby power consumption<0.5W for DA-Type NO LOAD STANDBY POWER CONSUMPTION WORKING TEMP. MAX. CASE TEMP. Tcase=-20 ~ +85℃ (Please refer to “ OUTPUT LOAD vs TEMPERATURE” section) Tcase=+85℃ BIS IS15885( for ODLC-45-700,1050,700DA,1050DA only), EAC TP TC 004,IP67 approved DALI STANDARDS Compliance to IEC62386-101, 102 for DA-Type only Hiccup mode,auto-recovery after fault condition is removed for DA type； Hiccup mode,re-power on to recovery for other type File Name:ODLC-45-SPEC 2020-11-30 fosc : 70KHz Block Diagram DIM+(DA+) DIM-(DA-) DETECTION CIRCUIT EMI FILTER RECTIFIERS POWER SWITCHING FILTER & RECTIFIERS RECTIFIERS Vo+ VoI P CONTROL & CURRENT LIMIT PWM&PFC O.L.P. 45W Constant Current Mode LED Driver ODLC-45 seri e s DRIVING METHODS OF LED MODULE ※ This series works in constant current mode to directly drive the LEDs. Typical output current normalized by rated current (%) In the constant current region, the highest voltage at the output of the driver depends on the configuration of the end systems. Should there be any compatibility issues, please contact MEAN WELL. 100 60 (min.) Vo(%) 50 100 Io(%) Constant Current area Hiccup Protection AUX+(for ODLC-45A) AUX-(for ODLC-45A) DIMMING OPERATION ※ 2 in 1 dimming function ‧Output constant current level can be adjusted by applying one of the two methodologies between DIM+ and DIM-: 0 ~ 10VDC, or 10V PWM signal. ‧Direct connecting to LEDs is suggested. It is not suitable to be used with additional drivers. ◎ Applying additive 0 ~ 10VDC ◎ Applying additive 10V PWM signal (frequency range 300Hz ~ 3KHz): Note : 1. Min. dimming level is about 8% and the output current is not defined when 0%< Iout<8%. 2. The output current could drop down to 0% when dimming input is about 0Vdc or 10V PWM signal with 0% duty cycle. +V -V DIM+ DIM- + + + – – – “DO NOT connect DIM- to Vo- Additive Voltage +V -V DIM+ DIM- + + – – “DO NOT connect DIM- to Vo- Additive PWM signal 0V 1V 2V 3V 4V 5V 6V 7V 8V 9V 10V 10% 0% 20% 30% 40% 50% 60% 70% 80% 90% 100% Output current (%) 0% 10% 20% 30% 40% 50% 60% 70% 80% 90% 100% 10% 0% 20% 30% 40% 50% 60% 70% 80% 90% 100% Output current (%) Dimming input: Additive voltage Duty cycle of additive 10V PWM signal dimming input File Name:ODLC-45-SPEC 2020-11-30 45W Constant Current Mode LED Driver ODLC-45 seri e s AUX+(Yellow)* AUX-(Green)* DIM+ DA+(Purple) DIM- DA-(Gray) ACL(Brown) ACN(Blue) ※ DALI Interface (primary side; for DA-Type) ‧Apply DALI signal between DA+ and DA-. ‧DALI protocol comprises 16 groups and 64 addresses. ‧First step is fixed at 8% of output. Vo+(Red) Vo-(Black) *AUX- AUX+ only for ODLC-45A 76 78 80 82 84 86 88 90 50% 60% 70% 80% 90% 100% 277V 230V 115V 0 2 4 6 8 10 12 14 16 50% 60% 70% 80% 90% 100% 277V 230V 115V 0.7 0.75 0.8 0.85 0.9 0.95 1 50% 60% 70% 80% 90% 100% 277V 230V 115V File Name:ODLC-45-SPEC 2020-11-30 PF LOAD OUTPUT LOAD vs TEMPERATURE STATIC CHARACTERISTIC TOTAL HARMONIC DISTORTION (THD) POWER FACTOR (PF) CHARACTERISTIC ※De-rating is needed under low input voltage. EFFICIENCY vs LOAD ODLC-45 series possess superior working efficiency that up to 86% can be reached in field applications. ※ 350mA Model,Tcase at 75℃ ※ 350mA Model,Tcase at 75℃ EFFICIENCY(%) THD(%) LOAD (45W) LO AD ( %) -20 -10 0 10 20 30 40 (HORIZONTAL) 20 40 60 80 100 90~295VAC for 350mA Model,200~295VAC for others 90~200VAC for models other than 350mA Model INPUT VOLTAGE (V) LO AD ( %) 90 295 100 90 80 70 60 50 40 135 180 for others for 350mA Model 200 LOAD 45W Constant Current Mode LED Driver ODLC-45 seri e s CASE TEMPERATURE (℃) LO AD ( %) -20 -10 0 15 30 45 60 85 (HORIZONTAL) 20 40 60 80 100 90~295VAC for 350mA Model,200~295VAC for others 90~200VAC for models other than 350mA Model AMBIENT TEMPERATURE,Ta (℃) ※ Tcase at 75℃ 50 File Name:ODLC-45-SPEC 2020-11-30 MECHANICAL SPECIFICATION 45W Constant Current Mode LED Driver ODLC-45 seri e s Case No.ODLC-45 Unit:mm Vo+(Red) Vo-(Black) DIM+ DA+(Purple) DIM- DA-(Gray) UL1007 22AWG UL1007 22AWG UL1007 18AWG UL1007 18AWG ODLC-45 DC wire No. Assignment(DC OUT) ODLC-45A DC wire No. Assignment(DC OUT) AUX+(Yellow)* AUX-(Green)* Vo+(Red) Vo-(Black) DIM+ DA+(Purple) DIM- DA-(Gray) ACL(Brown) ACN(Blue) 111 77 3.5 3.5 3.5 3.5 2*ψ4.5 28.5 2.5 150±10 200±10 150±10 200±10 30 30 tc ‧ : M tc ax. Case Temperature Please refer to : http: www.meanwell.com manual.html INSTALLATION MANUAL AC wire No. Assignment(AC IN) ACL(Brown) ACN(Blue) SVT 18AWG SVT 18AWG SVT 18AWG SVT 18AWG Vo+(Red) Vo-(Black) DIM+(Purple) DIM-(Gray) UL1007 22AWG UL1007 22AWG UL1007 18AWG UL1007 18AWG AUX-(Green) AUX+(Yellow) UL1007 22AWG UL1007 22AWG *AUX- AUX+ only for ODLC-45A